Remote Control Electric Trunk Retrofit for Jetour Freedom T1 2025-2026

The Freedom T1 arrived as a 2025 model with a tall, near-vertical tailgate — a shape that is great for load height but heavy to lift by hand, especially for shorter drivers. This retrofit kit addresses exactly that: a motorised actuator pair, a control module configured for the T1 body, and a wiring adapter that plugs into the factory tailgate connector on 2025 and 2026 build vehicles.

Why This Kit

• Electric trunk retrofit built for the T1 body — bracket geometry follows the vertical hinge line of the 2025-2026 panel so travel stays smooth through the full arc.
• Power lift gate open kit with remote control — the supplied fob works up to 30 metres on rolling code, and the factory handle switch and cabin button remain active.
• Plug-in wiring adapter — no cutting of the original harness; the adapter mates with the factory tailgate connector and only power and ground are wired separately.
• Obstruction reversal on both strokes — current monitoring stops and reverses the panel on contact, protecting people, pets and cargo.
• Height memory — the opening angle can be limited for low car parks and is retained after a battery change.
• Manual release retained — the original handle still works if power is lost, so the boot is never locked out.

Specifications

Installation Notes

Because the T1 is a recent platform, we supply a printed position guide showing the factory ball stud locations and the trim release order rather than relying on clips being identical to older Jetour models. Support the panel before removing the original struts, run the harness along the factory clip line, and terminate the fused lead at the battery junction box. First fit runs about 2 hours, repeat fits 70-80 minutes, and the conversion reverses without trace.

Target Market

Exporters moving early accessories for a newly launched model, particularly in the Middle East, CIS and Latin America where the T1 is being introduced; distributors who want to be first to market with a convenience feature for a new nameplate; and 4x4 accessory shops serving lifestyle SUV buyers. Newly launched models usually have thin aftermarket supply for the first 12-18 months, which is where margin sits.

Packing and Warranty

Each set ships in a printed carton with foam-cradled actuators, labelled fasteners, the printed position guide and a bilingual fitting manual, inside a five-ply export box. Bench testing covers 400 duty cycles, synchronous travel, reversal force, remote pairing and standby current. Production follows ISO 9001:2015; warranty is 24 months on actuators and 12 months on the control module.