Two mid-size SUVs, one drive kit. This package supplies a control module plus two labelled bracket and adapter sets that fit the Soueast S09 and the Jetour X90, so a distributor can carry a single reference for both models. The "drive" in the name refers to the actuator pair itself: motorised lift units that replace the factory gas struts and take over the opening and closing effort entirely, leaving the original latch and lock untouched.
| Parameter | Specification |
|---|---|
| Compatible Models | Soueast S09, Jetour X90 |
| System Voltage | 12V DC |
| Drive Type | Twin motorised lift actuators with ball-socket ends |
| Rated Thrust | 410 N per actuator |
| Tailgate Mass Supported | Up to 47 kg |
| Fitment Selection | DIP switch, two presets |
| Remote Range | Up to 30 metres, rolling code |
| Cycle Time | 7-9 seconds each direction |
| Safety | Bidirectional obstruction reversal, over-current cut-off, P-gear interlock |
| Sealing | IP54 module, IP65 actuators |
| Operating Range | -30 C to +80 C |
| Net Weight | 7.0 kg per set |
Identify the vehicle, set the matching preset on the module, then fit the bracket set carrying that model label. Both SUVs use clipped rear trim panels; the S09 needs the upper panel released around the glass before the main trim, while the X90 comes away from the grab-handle screws first. Brackets use the original strut studs on each car, the adapter plugs into the factory tailgate connector, and only the fused power lead plus ground are wired directly. First fit runs 2 to 2.5 hours, repeats 60-80 minutes, fully reversible on both models.
Exporters covering the Middle East, North Africa, Latin America and CIS regions where Jetour and Soueast SUV volumes are climbing; multi-brand accessory distributors looking for one reference covering two SUVs; ride-hailing and tourism fleets; and mobile fitters who want flexibility from a single carton. Because both models remain in production, repeat orders and spare parts support are predictable.
Cartons contain the module, two labelled bracket sets, two adapters, fasteners and a bilingual fitting guide, protected by die-cut foam inside a five-ply export box. Every set is cycle-tested 400 times, with checks on reversal force, synchronous travel, remote pairing and standby current. Production follows ISO 9001:2015; warranty is 24 months on actuators and 12 months on the control module.