Tailored for damp park landscaping, this termite resistance WPC tube garden louver protects park partitions from insect damage. Supplied with a comprehensive quick installation guide, it enables local assembly crews to mount profiles without errors.

• Engineered Immunity to Subterranean Termites: Contains non-organic materials woven into the matrix, making the garden louvers entirely inedible to wood-boring pests.
• Foolproof Assembly via Quick Installation Guide: The detailed illustrated manual takes away the guesswork, reducing alignment trial and error and cutting site labor hours significantly.
• Perfect Longevity for Ground Contact Areas: Ideal for garden screen walls that sit close to insect-rich wet soil, ensuring the profile stays intact without pest hollow-out failures.
• Reduced Training Costs for Landscape Contractors: The combination of pre-shaped profiles and a step-by-step guide allows smaller crews to finish park screens with minimal training.

• Connector joint: Use matching metal/plastic internal/external connectors. Pre-drill holes + fix with stainless steel self-tapping screws.
• Adhesive bonding: Apply WPC-specific adhesive/structural glue. Clean → glue → join → clamp → cure (24h).
• 45° miter joint: Cut ends at 45° for corners; secure with angle brackets and screws.

• Clip-on (quick install): Use aluminum spring clips to attach directly to metal studs/frames; no screws, removable.
• Bracket/angle fix: Use stainless steel L-brackets. Pre-drill tube walls, fasten to wall/ceiling substrate.
• Pipe clamps/hangers: For horizontal runs, use U-clamps/hangers on light steel keels; spacing ≤ 60cm.
• Post mounting (fence/grille): Embed posts in concrete or fix to ground with flange plates + expansion bolts.

• Cutting: Use fine-tooth saw/circular saw; keep cuts clean and deburred.
• Expansion gap: Leave 3-5mm between tubes for thermal expansion.
• Pre-drill: Always pre-drill before screwing (hole ≈ 3/4 screw diameter) to avoid cracking.
• Drainage: Install outdoor tubes with slight slope or drill drain holes to prevent water buildup/mold.