Purpose

This 24V rectangular LED bus step light (OEM No.24126KJ0003) is installed at the passenger door of coaches and buses. It provides sufficient illumination for entry steps when passengers board and alight. It effectively avoids stumbling risks under dim light conditions and improves passenger getting‑on‑and‑off safety. Widely applied for step lighting of various passenger coaches.

Product Features

1. DC 24V operating voltage, matches standard electrical system of buses and coaches.

2. LED light source, low power consumption and long service life.

3. Compact rectangular housing structure with high‑transmittance transparent lens.

4. Built‑in foam sealing gasket on rear side for shock absorption and dust‑proof sealing.

5. Equipped with waterproof plug‑in connector for quick connection.

6. OEM part number 24126KJ0003, direct replacement for original bus spare parts.

Product Advantages

1. Excellent anti‑vibration performance, adapts to bumpy road conditions of bus operation.

2. Rear foam gasket fills installation gaps, reduces vibration noise and blocks dust and moisture.

3. Waterproof connector prevents circuit faults caused by water ingress.

4. Compact rectangular outline, fits many reserved rectangular mounting holes on bus passenger doors.

5. Original‑equivalent quality, perfect spare part for maintenance and replacement.

6. Plug‑and‑play design, no cutting or modification of original vehicle wires.

Installation Instructions

1. Cut off the 24V power supply of passenger‑door circuit before installation to prevent short‑circuit damage.

2. Remove the old step lamp and clean dust and residues from the mounting surface.

3. Align the lamp body with the reserved rectangular mounting hole.

4. Fasten the lamp with fixing screws. Do not over‑tighten screws to avoid shell cracking.

5. Insert the waterproof plug into vehicle‑side socket firmly until you hear the locking click sound.

6. Restore vehicle power supply, open passenger door and test whether the lamp lights normally.

7. Adjust position slightly if necessary to ensure light covers the step surface.

Notes

1. Confirm power input is DC 24V before installation. Never connect to power sources of other voltages.

2. Make sure plug and socket are free of water, dust and debris before connection.

3. Do not knock, squeeze or impact lamp housing during installation.

4. Regularly clean dirt on transparent lens to maintain good lighting effect.

5. Periodically check plug connection. Loose connection will lead to intermittent lighting failure.

6. Do not disassemble internal LED module privately, or the spare‑part warranty will become invalid.

7. Inspect the aging status of back foam gasket; replace gasket once it fails to seal, avoid water seepage.