Purpose

This 24V long‑strip LED bus step light (OEM No.24126AJ0002) is applied to the passenger door area of coaches and buses. It provides bright illumination for entry steps when passengers get on and off. It reduces trip hazards under dim conditions and improves boarding safety. Widely used for step lighting of various passenger buses.

Product Features

1. DC 24V working voltage, perfectly matching bus electrical system.

2. High‑brightness LED light source, low power consumption and long service lifespan.

3. Long‑strip slim profile, fits narrow reserved installation positions on bus passenger doors.

4. Equipped with waterproof plug‑in connector for quick plug‑and‑play connection.

5. Foam sealing gasket on the back for shock absorption and dust‑proof sealing.

6. OEM part number 24126AJ0002, direct replacement for original bus spare parts.

Product Advantages

1. Good vibration resistance, adapts to continuous bumpy driving conditions of passenger buses.

2. Back foam gasket fills installation gaps, reduces vibration noise and prevents dust and water ingress.

3. Waterproof connector effectively avoids circuit damage caused by moisture.

4. Slim long‑strip design covers larger step lighting area than round or oval step lamps.

5. Original‑equivalent quality, ideal maintenance replacement spare part.

6. No wire cutting or modification required for installation.

Installation Instructions

1. Disconnect the 24V power supply of the passenger‑door circuit before installation to prevent short‑circuit damage.

2. Remove the old step lamp, clean up dust and residual sundries on the installation surface.

3. Tear off the protective film of the back foam gasket, align the lamp body with the mounting position.

4. Fasten the lamp with mounting screws. Do not over‑tighten screws to avoid shell deformation.

5. Firmly insert the waterproof plug into the vehicle‑side socket until the locking buckle clicks.

6. Restore vehicle power supply, open passenger door and verify that the lamp lights up normally.

7. Fine‑tune position if needed to ensure light fully covers the step surface.

Notes

1. Confirm input voltage is DC 24V before installation. Never connect to power supply of other voltage.

2. Keep the waterproof plug and socket free of water, dirt and debris during connection.

3. Do not strike or squeeze the lamp housing during installation.

4. Regularly clean dust on the transparent lens to maintain good lighting output.

5. Periodically inspect the plug connection. Loose connection will cause intermittent lighting failure.

6. Do not disassemble the internal LED module privately, which will invalidate the spare‑part warranty.

7. Check the sealing condition of back foam gasket. Replace the gasket if it ages, to prevent water penetration.