The DC860 is designed for large commercial and industrial floor areas. Its 860mm scrubbing width and rated cleaning efficiency of up to 6,000m²/h make it suitable for factories, warehouses, logistics facilities, parking garages, shopping centers, stations and other open floor areas.

The theoretical coverage is approximately 30,000–36,000m² per charge. This estimate is calculated from the rated efficiency of 6,000m²/h and the specified working time of 5–6 hours. Actual coverage will be lower because of turning, overlapping, refilling, draining, obstacles, floor condition and operator speed.

The machine requires entrances and operating routes wider than its listed 1,150mm overall width. Its dimensions are 1,550 × 1,150 × 1,250mm. Buyers should measure doors, elevators, aisles, ramps, turning spaces, charging areas and storage entrances before ordering.

Yes, the 150L clean-water tank and 180L recovery tank are intended for extended industrial cleaning cycles. The larger recovery tank provides capacity for collected wastewater and foam. Actual operating time between service stops depends on water-flow settings, floor contamination and the cleaning route.

The DC860 can handle demanding floor conditions with adjustable brush pressure of 35–50kg and two 550W brush motors. Results also depend on brush or pad material, detergent, dwell time and floor type. Buyers should test the proposed brush and chemical combination on representative flooring before bulk purchase.

The 1,150mm squeegee and 500W suction motor are designed to recover wastewater during scrubbing, but drying performance must be verified under actual site conditions. Squeegee-blade material, blade adjustment, floor joints, turns, oil contamination and operating speed can all affect residual water.

The listed configuration includes a 650W front-drive motor, two 550W brush motors and a 500W suction motor. The maximum listed travel speed is 7km/h. Buyers should confirm motor brands, protection ratings, controller specifications and replacement-part availability in the final purchase agreement.

The DC860 uses a 24V electrical system, but battery capacity and battery chemistry are not specified in the supplied parameter sheet. Buyers should confirm ampere-hour capacity, lead-acid or lithium chemistry, charging time, charger input voltage, plug type, battery warranty and relevant shipping documents before ordering.

The DC860 requires planned freight handling because its listed machine weight is 400kg. Confirm packed dimensions, gross shipping weight, packaging material, forklift points, container loading method, battery transport documentation and the unloading equipment available at the destination.

Confirm the complete battery, charger, brush, squeegee, safety and spare-parts configuration in writing. The purchase specification should include battery capacity and chemistry, charger voltage and plug, brush or pad type, squeegee-blade material, water-flow controls, working gradient, braking system, warranty coverage, spare consumables, packaging details and after-sales support.