Self-Adhering Hangers are designed to attach insulation to clean, dry, smooth, non-porous surfaces. After the hanger is installed, the insulation is impaled over the spindle & secured with a self-locking washer. Due to the nature of adhesives, it is important that the user read & follow the guidelines. It is the responsibility of the user to determine the suitability of the intended application.

Material: Galvanized Steel (Standard) Available in Stainless Steel & Aluminum as special order.

Other details: Standard Lengths are listed above. Other lengths available as Special Order.

Packaging: 1,000 pcs/ctn up to 2-1/2", 500 pcs/ctn up to 8". Hangers are available packed with, or without washers. 100 pc packaging also available. Other diameters available as Special Order. A complete line of Self-Locking Washers in various styles and materials is available for use with Self-Adhering Insul-Hangers.

• Suitable for all kinds of wall
• High pull-off strength for a higher security of the system
• Low thermal conduction addition value to avoid thermal bridge
• Galvanized layer on the steel nail to protect the nail from alkali

Application: It is fixed on the position where there is significant wind-suction-force or if the height is more than 20m or if the finishing coat is tile etc.

Installation Steps:

1. WIPE SURFACE CLEAN. Anchor should be applied to a clean, dry non-porous surface
2. PEEL OFF RELEASE BACKING. NOTE: Double faced foam tape has a one-year active shelf life
3. STICK ANCHOR IN PLACE. Select location before contact with surface. Press firmly
4. APPLY FIRM PRESSURE. 20 pounds of pressure should be applied all around the base of the anchor
5. ALLOW TO STAND 15-20 MINUTES. This will permit better adhesion to take place
6. INSTALL INSULATION AND SECURE WITH WASHER. Recommended load is 3 lbs. per anchor (.75 lbs./sq. inch maximum)

Self adhesive hanger and SELF-STICK ANCHORS from huihao company.

500 or 1000 units per carton or plastic bag.