Hands-Free Power Liftgate for the GAC Trumpchi GS4 III (GS4 Max)

The third-generation GS4, marketed as the GS4 Max in several regions, has a taller and heavier rear door than the earlier cars. This kit is prepared for that body: longer stroke, higher actuator rating and a harness cut to the GS4 III loom.

Generation and Market Names

GS4 III and GS4 Max refer to the same generation in different markets. Brackets and stroke in this kit match that generation only; first and second generation GS4 cars use different references. Buyers should confirm the model year before ordering.

Hands-Free Operation

The optional foot sensor bar sits under the rear bumper and reads a short sweep of the foot. That lets a driver load shopping, luggage or a child seat without putting anything down. The bar is separate from the actuator circuit, so it can be added later without touching the installed hardware.

Highlights

• Open and close from the factory key, cabin switch or tailgate button.
• Actuators rated 560 N for the larger GS4 III door.
• Soft final latch pull, with three warning beeps before each cycle.
• Reverse on obstruction via hall feedback and current monitoring.
• Stored opening height with a damped approach in the last phase.
• Manual override always available.

Specifications

Installation

Rear headliner trim and quarter panel clips come off with plastic tools, factory struts release, and the handed brackets mount on existing hinge points. The harness follows the GS4 III hatch loom through the factory grommet and ends in moulded plugs. Bracket bolts at 22 Nm. Around two hours for a first car.

Packing and Stock

Carton 83 x 23 x 20 cm, one set per carton, five cartons per master. Actuators sleeved in EPE, module in a rigid insert, hardware in numbered bags by side. GS4 III actuators are held in rolling stock so repeat orders ship within days. Buyer labels and barcodes available.