| 1 | Maximum permissible ripple current | Temperature:1052, Ripple frequency:100KHz | Refer to table |
| 2 | Surge | Temperature:1052, Duration:1000 cycles | 1.No electrical or mechanical damage. 2.Capacitance change within 15%. 3.D.F. smaller than specification value. 4.Leakage current smaller than specification value. |
| 3 | Temperature Cycle | One Cycle: Rated high category temperature3 (303 min) to 25 (3MAX min), Rated low category temperature3 (303 min) to 25 (3MAX min). Total number of cycles: 5 | 1.No appearance defect. 2.Capacitance change within 5%. 3.D.F. smaller than specification value. 4.Leakage current smaller than specification value. |
| 4 | Resistance to Soldering Heat | Warm up time: 1202 seconds to reach 1202, Solder bath temperature: 2605, Immersion depth: 1.5 to 2.0mm, Immersion duration: 101 seconds | 1.No appearance defect. 2.Capacitance change within 5%. 3.D.F. smaller than specification value. 4.Leakage current smaller than specification value. |
| 5 | Solder Ability | Solder bath temperature: 2355, Immersion depth: 1.5 to 2.0mm, Immersion duration: 101 seconds | A minimum of 95% the immersed surface is to be coated with the new solder |
| 6 | Low Temperature Characteristics (Max.Impedance Ratio) | Working Voltage (V): 6.3, 10, 16, 25, 35, 50, 63, 100 | Impedance Z-40/+20: 8, 6, 4, 3, 3, 3, 3, 3 |
| 7 | High Humidity Storage | Temperature:402, Relative humidity:90 to 95%, Duration:2408 hours | 1.No electrical or mechanical damage. 2.Capacitance change within 15%. 3.D.F. smaller than specification value. 4.Leakage current smaller than specification value. |
| 8 | Vent | Conduct under normal lighting for lab work | There shall be no explosion, flash, flame, spark or fire from the capacitor during or after the test, nor shall there be expulsion of any metal from the casing |
| 9 | Terminal Strength (Tensile/Bending) | Continued time: 101sec | 1.No electrical or mechanical damage. 2.No appearance damage. |
| 10 | Vibration | Frequency range: 10 Hz to 55 Hz, Amplitude: 1.5 mm, Cycle duration: 1 minute, Duration: 2 hours per direction (3 directions) | 1.No electrical or mechanical damage. 2.No appearance damage. |
| 11 | Endurance | Capacitors are placed in an oven and applied voltage for 3000 hours at 105. After being restored to 25, capacitors shall meet the specifications. | 1.Capacitance change within 20% of the initial value. 2.D.F. change within 200% of the specified value. 3.Leakage current smaller than specification value. |
| 12 | Shelf Life | Capacitors are placed in an oven for 1000 hours at 105 without applying rated working voltage. After being restored to 25, capacitors shall meet the specifications. | 1.Capacitance change within 20% of the initial value. 2.D.F. change within 200% of the specified value. 3.Leakage current within 200% of the specification value. |