Cemented Tungsten Carbide Welding Rod Good Thermal & Chemical Stability

Tungsten Carbide Welding Rod Application

1. Thoroughly clean the base metal.
2. Lightly heat base material then apply flux.A little heat before applying powdered flu: helps it stick to the base material, as the torch has a tendency to blow the flux away.
3. Gently heat the base material to melt flux, observe its coverage and oorrect any bart
4. Applying a coating of Tung chip Tinning Rod can assist in the adhesion of th Composite Rod to the base material. The tinning rod can also be used to fill voids an give a smooth appearance if required.
5. Heat base material until it just begins to turn red. At this point begin applying rod t base material. The Tung chip Tinning Rod should flow onto the base material. If the Tunt chip Tinning Rod balls up, it is not hot enough. Adversely, if the Tung chip Tinning runs across the base material it is too hot. Care must be taken to maintain the prope temperature of the base material during application.
6. Composite Rod is sluggish and does not flow easily.How it flows can vary considerable depending on the size and percentage of the Tung chip Tungsten Carbide Grit in the rod Explanation of the exact technique for application is difficult but certain general advice can be given.Work slowly and gently with as little heat as possible.Allow the Composit Rod to precede the torch rather than follow it.If necessary use the rod as a pushing packing and smoothing tool while applying just enough heat to melt the matrix.It woulk probably be beneficial for the beginner to practice on a scrap piece of steel before tackling the actual parts to be hardfaced.With practice good coatings can easily be made.

Tungsten Carbide Welding Rod Grade

Q&A

Q1: Are you a factory or a trading company?

A: We are a factory. We have been focusing on Tungsten Carbide for over 20 years.

Q2:What is your principle for the samples?

A: We offer free samples if you are willing to pay the freight.

Q3:What is your delivery time?

A: Generally it is 5 to 7 days if your required goods are in stock, otherwise it takes 20 to 30 days when there is no stock.

Q4:Do you have any test reports or certificates?

A: Yes, we can offer certificate of ISO9000:2008, we also report our test results for your reference.

Q5: Do you provide after-sale service?

A: Yes. So if you find any problem after using our cutting tools, please do not hesitate to tell us, we’ll help you to solve it as soon as possible. Your any feedback to products is our way to improvement

Q6: What should I do before contacting?

A: You can provide specific dimensions or drawings, and tell us the quantity of each item, and your application of this item. Other special requirements is also available.

Q7:How to contact us?

A: Directly contact us from inquiry, or by whatsapp or wechat. Other ways you can also provide us.

Packaging & Delivery:

Packing Details:

Plastic Boxes Inside and Cartons Outside

Port:

Guangzhou/Shanghai/Shenzhen/Dalian etc.

Delivery Details:

Generally it is 5-7 days if the goods are in stock.

Or it is 20-30 days if the goods are not in stock, it is according to quantity.