Brush Steel Wire Spool for Consistent Brush Tufting

Brush steel wire is used for industrial brush manufacturing, where tufting quality depends on stable wire diameter, controlled straightness and consistent surface condition. This wire is cold drawn and supplied on BS60, BP60 or DIN wooden spools, with diameters selectable within the 0.15-12mm range.

Typical grades are 304, 316 and 316L. Grade 304 covers general brush applications; 316 and 316L are selected for brushes exposed to moisture, cleaning agents or food-contact environments. Diameter tolerance and winding are inspected before packing, because uneven wire affects tuft density and brush balance.

Specifications

Applications

Industrial Wheel and Roller Brushes

Wire sections for wheel brushes, roller brushes and cup brushes used in deburring, descaling and surface preparation.

Brush Tufting and Stapling

Consistent diameter and controlled straightness support uniform tuft density and predictable tufting machine behavior.

Cleaning and Polishing Brushes

Brushes for cleaning, polishing and surface finishing, where wire surface condition affects the finished result.

Food and Hygiene Brushes

316 and 316L grades are selected for brushes used in food processing and hygiene-sensitive areas.

Product Advantages

• Controlled diameter tolerance - diameter and tolerance are checked per batch, supporting uniform tuft density and stable brush balance.
• Annealed ductility - the annealed condition supports tufting and stapling with reduced risk of wire breakage during brush assembly.
• Bright inspected surface - surface condition is inspected for cleanliness and appearance, suitable for visible brush products.
• Standard wooden spool options - BS60, BP60 and DIN spool formats match common brush-making equipment and handling practice.
• Full range 0.15-12mm - one supplier for fine brush wire and heavier brush sections, with 304 / 316 / 316L options.

Quality Control

Each batch is inspected for material grade, wire diameter, dimensional tolerance, surface condition, winding quality and spool packing against the agreed specification. Test reports are available per shipment.

Quick Selection Guide

1. Confirm the brush type (wheel / roller / cup / hand brush)
2. Select the wire diameter within 0.15-12mm
3. Select the grade (304 for general use; 316/316L for wet or food-contact use)
4. Confirm the spool type (BS60 / BP60 / DIN)
5. Specify surface and mechanical requirements

Send your grade, diameter, spool type and brush application for a technical confirmation and quotation.