One-Stop Engineering & Manufacturing Capabilities

Customization and R&D Capability

Our engineers custom-develop the charging board and its firmware for your product, so the power stage fits your form factor, wattage and protocol requirements.

• ODM design-in — controller, power stage and port configuration tailored to your wattage and port count.
• Hardware and firmware co-development — PD protocol negotiation, protection logic and code built together on the board.
• Protection engineering — over-voltage, over-current, over-temperature and short-circuit safeguards built in.
• Feature expansion — add multi-port, display, GaN power stage or pass-through data to an existing platform.
• Confidential development — NDA-protected engineering with clear design ownership for your brand.

Cost Reduction and Efficiency for Your Project

We do more than populate boards — we lower your total cost and shorten your time to market.

From Bare Board to Finished Product (Box-Build)

A bare PCBA is only a component. This service carries the board all the way into a finished charging product that ships ready to sell.

1. Schematic Design — lock the electrical architecture.
2. PCB Layout — deliver a manufacturable, high-current and EMC-conscious board.
3. Component Sourcing — secure the BOM through trusted channels.
4. DFM / DFA Review — de-risk the build before tooling.
5. SMT and DIP Assembly — populate and solder the PCBA.
6. Firmware Development — bring the board and PD protocol to life.
7. Functional Testing — verify every function passes.
8. Box-Build Assembly — fit the PCBA into the enclosure, wire harnesses and connectors, then seal and finish the unit into a complete product.
9. Prototype and Mass Production — start with samples, then ramp to volume with the same process.