| Operating Temperature | -55C to +125C | Maximum operating temperature with no voltage derating: +85C |
| DC Leakage current | Shall be satisfied the value on "Standard list" | Rated voltage for 5min |
| Capacitance tolerance | 20% | Measuring frequency: 10010kHz, Measuring voltage: 0.5Vrms or less |
| Equivalent series circuit Tangent of loss angle (Df, tan ) | Less than 200% of initial limit | Measuring frequency: 12012Hz, Measuring voltage: 0.5Vrms +1.5V.DC |
| Impedance | Shall be satisfied the value on "Standard list" | At 85C, At 125C |
| Resistance to Soldering heat | Appearance: No significant abnormality, Indications: Clear. Df (tan ): Less than 200% of initial limit. L.C.: Less than 200% of initial limit. | Dip in solder bath: Solder temp: 2605C, Duration: 50.5s, Repetition: 1 |
| Temperature cycle | Appearance: No significant abnormality, Indications: Clear. Df (tan ): Less than 1000% of initial limit. L.C.: Within 20% of initial value. | 5 cycles (1 cycle: steps 1 to 4) without discontinuation. -553C (303min.) to 1252C (303min.) |
| Moisture resistance | Appearance: No significant abnormality, Indications: Clear. Df (tan ): Less than 200% of initial limit. L.C.: Within 30% of initial value. | 602C, 90 to 95% RH for 50012h |
| Temperature Stability | Appearance: No significant abnormality. Df (tan ): Shall be satisfied the voltage on "Standard list". L.C.: Shall be satisfied the voltage on "Standard list". | -55C, +85C, +125C |
| Loading at High temperature | Df (tan ): Less than 300% of initial limit. L.C.: Less than 200% of initial value. Appearance: No significant abnormality. | Rated voltage for 1000+36/0 h at 852C |
| Terminal strength | The measured value should be stable. | Apply force to the terminal until it bends to 1mm and maintain for 5s. |
| Adhesiveness | The terminal should not come off. | Apply force of 1N in two directions after mounting on a circuit board. |
| Resistance to solvents | The indication should be clear. | Dip in isopropyl alcohol for 305s, at room temperature. |
| Solderability | 3/4 or more surface area of the solder coated terminal dipped in the soldering bath should be covered with the new solder. | Dip speed=252.5mm / s, Solder temp. : 2455C, Duration : 30.5s |
| Capacitance Vibration | Measure value should not fluctuate during the measurement. | Frequency: 10 to 55 to 10Hz/min. Amplitude: 1.5mm, Time: 2h each in X and Y directions |