This specification applies to the PH series strip connector, covering product performance, test methods, and inspection requirements. It is designed for electrical connections with specific environmental and mechanical performance standards.
| Item | Description | Requirement | |
| Scope | Contents of specifications apply to PH series connector strip | Product performance, test methods and inspection requirements | |
| Applicable Standards | GB/T2421, GB/T2423, GB/T2424, GB/T5095 | ||
| Use Condition - Ambient Temperature | -25 +85 | ||
| Use Condition - Applicable Wire Sizes | AWG #2228 | ||
| Material | Terminal Contact | Phosphor bronze, 0.2mm thick, Tin plating: 35m | |
| Housing Plastic | Nylon66 UL94V-0, Color: White | ||
| Wafer | Brass, 0.50mm thick, Tin plating: 2.55m, Color: Beige | ||
| Electrical Performance | Rated Voltage | 250V AC/DC | |
| Rated Current | 2A AC/DC | ||
| Withstand Voltage | 800V AC (rms) for 1 minute between adjacent contacts, leakage current < 0.5mA | No breakdown or flashover | |
| Insulation Resistance | 1000 M | ||
| Mechanical Performance | Single contact insertion force | 6N | Test rate: 253mm/min |
| Single contact Withdrawal force | 0.5N | Test rate: 253mm/min | |
| Terminal crimping Wire strength | AWG#22: 50N, AWG#24: 30N, AWG#26: 20N, AWG#28: 13N | Test rate: 253mm/min | |
| Pin Retention Force | 15N | Test rate: 253mm/min | |
| Seat pull-out force | 15N | Test rate: 253mm/min | |
| Durability | Contact Resistance 30m | 30 cycles, 10 cycles/min max rate | |
| Vibration | Current Discontinuity: 1 sec Max, Contact Resistance 30m | Amplitude: 1.5mm p-p, Frequency: 10-55-10Hz/min, 2 hours per direction (X, Y, Z) | |
| Environmental Performance | Thermal Aging | Contact Resistance 30m, Appearance: No damage | 852, 96 hours |
| Temperature Cycling | Appearance: No damage, No breakdown or flashover | -553 (30min) to 853 (30min), 5 cycles | |
| Constant Humidity | Contact Resistance 30m, Insulation Resistance 500m, Appearance: No damage | 402, 90-95% RH, 96 hours | |
| Salt Spray | Contact Resistance 30m, Appearance: No damage | 353, 51% NaCl solution, 8 hours (pre-plated) or 24 hours (post-stamped) | |
| Soldering Performance | Solder ability | Soldering Area 90% | 2455C, 30.5S (tin pot) |
| Resistance to soldering heat | Appearance: No damage | Hand soldering: 3505C, 30.5S; Wave soldering: 2305C, 50.5S |