4 Leg Tubular GSM MW Antenna Telecommunication Tower Accessories

The steel tube communication tower is mainly suitable for pull towers. Its main material is mainly made of steel pipe, because its root can be made very small, suitable for narrow sites or near the building, but the cost is higher than the angle steel Lattice tower.

Specification of Telecommunication Tower Accessories:

Feature of Antenna Telecom Steel Tower:

1. Communication steel Lattice tower height: refers to the vertical distance from the base of the tower foot to the installation location of the lightning rod;

2. Wind pressure requirement: Determine the wind pressure according to W0=V02/1600 by taking the average maximum wind speed V0 (m/s) of the 10-year once-in-tact 10-minute period of the local comparatively empty ground and flat surface with a height of 10m. kN/m2;

3. Full-load wind load: Calculate based on the number of antenna layers and the number of microwave antennas per layer, and the antenna diameter in a specific project;

4. Communication tower flexion angle: less than 1 degree;

5. Center tilt: The verticality of the tower shall not be greater than 1/1500 of the height of the steel Lattice tower ;

6. The period of preservation: not less than 30 years in the local environment;

7. Galvanizing requirements: General thickness greater than 86 microns, uniform thickness, smooth surface. The specific situation is determined according to the specific project;

8. Classification by material: angle steel towers, steel pipe towers.

9. Classification by structure: four-posted angle steel towers, three-column steel tube towers, single-tube towers (single tube towers), and pull-line towers.

10. According to the support methods: self-standing towers, pull-line towers;

11. The types of communication towers of our company: general communication towers, beautification communication towers, bionic tree communication towers, and landscape communication towers.