Rotary Blade Coaxial Cable Stripper HDPE layer Stripping Machine

Features:

A programmable multi-layer coaxial wire stripper for coaxial cable, triaxial cable, shielded cable.

The machine can handle cables with 3-25mm. For example: rf1.13;rf1.78,rf3.16;rg58,rg59;rg1.41 and so on.

The machine's program can be flexibly stored and transferred to facilitate the processing of different diameter wire.

Stable head technology for rapid processing of wire, Swiss tungsten steel blade material to ensure the life of the blade and precision.

We also have other models Semi-auto coaxial wire stripping machine and full-auto coaxial wire stripping machine with different features

If you are not so sure which one is the best for you, please contact us, we will recommend the appropriate model to you!

Tested video of your sample is also available.

Matters needing attention:

I.The thread of automatic wire stripper can not be stripped.

1.Check the cutting depth of the thread. If it is too shallow, increase thread diameter.

2. The clearance between the upper and lower wheels on the intake pipe line is too large and the adjustment is small.

3. Inlet wheel screw pressure is not enough, need to be compressed.

4. The head stripping data is too small and needs to be increased.

II.The tail of automatic wire stripping machine can not be peeled off.

1. Check the cutting depth at the end of the wire.
1.If it is too shallow, increase the line diameter in function key F3 or increase the data at the end of the line.

2. The clearance between the upper and lower wheels of the outgoing line is too large and the adjustment is small.

3. The pressure of outlet wheel knob is not enough, so it needs to be tightened.

4. Tail stripping data is too small and needs to be increased.

III. Automatic wire stripping machine has a slope of the wire head.

1. Position the catheter or small diameter catheter so that the wire passes through the catheter and the cutting edge in a straight line.

2. The distance between the front end of the catheter and the cutting edge is too far, so it needs to be adjusted to get close to it.

3. The catheter does not jump up and down.Turn on the catheter jump switch in function key F4.

IV. Automatic wire stripping machine head and tail core copper wire cut off a few.

If the wire diameter is too large, reduce the wire diameter and try again until the copper wire in the wire core is not damaged.

V. The end or end of a thread is accidentally cut.

1. The blade is covered with leather or other stolen goods and needs to be cleaned.

2. The drive belt of the tool rest is too loose and needs tightening.

VI. Automatic wire stripping machine and the end of a few with copper wire slightly longer.

1. The wire diameter is too large, so the copper wire is cut out by a knife during stripping, so the wire diameter needs to be reduced.

2. The retreat data is too small and needs to be increased.

VII. The automatic wire stripper does not cut the wire.

1. Reduce tool speed and try again.

2. The blade becomes blunt and needs to be removed and replaced with a new one.

3. When the upper and lower blades are closed, there is a gap in the plane, and the upper and lower blades should be firmly installed.