The WLT-1230 (BL-1230) high-flow submersible pump is engineered for applications that require a large volume of water to be moved at a relatively low head. It delivers a rated flow of 500 m³/h at 8 m head and is powered by a 22 kW submersible motor.
This model is suitable for large-scale drainage, flood control, agricultural water transfer and other projects where pumping capacity is more important than high discharge pressure.
| Model | WLT-1230 |
|---|---|
| Alternative model | BL-1230 |
| Pump type | High-flow submersible pump |
| Rated flow | 500 m³/h |
| Rated head | 8 m |
| Motor power | 22 kW |
| Installation | Submerged installation |
Material, voltage, frequency, outlet dimensions, cable length and installation accessories should be confirmed according to the specific project requirements.
At its rated operating point, the pump can deliver approximately:
Actual output depends on the total system head, pipeline resistance, water level and installation conditions.
The rated head of 8 m makes this model suitable for moving large quantities of water over a limited vertical elevation. The required total head should include:
If the actual system head is significantly higher than 8 m, the pump may not deliver the required 500 m³/h. The final selection should therefore be checked against the performance curve.
The pumped liquid must be compatible with the pump materials and hydraulic passage. Solids, fibres, sand content, salinity and corrosive chemicals should be confirmed before ordering.
Because the pump operates directly in the water, it does not require a conventional suction pipeline or suction priming. This reduces the suction-loss problems commonly associated with surface pumps.
Submerged installation also allows the pump to be used in pits, ponds, channels and temporary drainage areas with limited space for above-ground equipment.
The installation location must provide sufficient water around the pump inlet. Inadequate water depth or a poorly designed intake may create vortices, introduce air or reduce pump performance. Before installation, confirm:
The 22 kW motor should be connected to a correctly rated control panel. Recommended protection includes:
Please provide the following details to ensure an accurate pump selection:
Send your operating conditions to confirm whether the WLT-1230 (BL-1230) matches your project. The quotation should clearly state the performance curve, materials, electrical specifications, outlet dimensions, cable length and included accessories.