Water Guide Bearing-Stainless Steel PREM
Applied to Hydro bearing, Marine bearing, Pump bearing.

INDRON® PREM:Grade of superior type
Based on TSTN, INDRON®PREM improves the compression resistance of the material, that is, the bearing capacity is especially suitable for horizontal or inclined shafts. PREM has a better effect than TSTN on vertical pumps.
| Material Grade |
| Bearing(lining) | INDRON®TSTN | INDRON®HRBR | INDRON®HAWF | INDRON®UNIV | INDRON®PLAT |
| Material | Synthetic Engineering Elastomers | Synthetic Engineering Elastomers | SyntheticEngineering Elastomers | Synthetic Engineering Elastomers | Synthetic Engineering Elastomers |
| Recommended Workplace | Guide Bearings & Seals | Guide Bearings& Seals | Guide Bearings & Seals | Guide van, connecting rod bushing | Guide vane, connecting rod bushing |
| Temperature Limit | 70℃ | 70℃ | 70℃ | 70℃ | 70℃ |
| Dry Rub | Yes | low speed | low speed | Yes | Yes |
| Acid Resistance | limit | limit | limit | limit | limit |
| Alkaline Resistant | limit | limit | limit | limit | limit |
| Hydrocarbon Suitability | Yes | Yes | Yes | Yes | Yes |
| Abrasion Resistance | good | excellent | excellent | good | good |
| Friction Pair(bushing) | bronze | HRC40 | HRC40 | HRC40 | HRC40 |
| Stainless | recommend | recommend | recommend | recommend |
| Typical Application | water, sea water | water, sea water | water, sea water | water, sea water | water, sea water |
| Most fluids(pH 5-10) | Most fluids(pH5-10) | Most fluids(pH5-10) | Most fluids(pH 5-10) | Most fluids(pH5-10) |
| Note | Lowest coefficient of friction,suitable for dry running applications, good wear resistance | Use silt water under moderate grinding conditions | Use ofsilt-containing water under high grinding conditions. Contains abrasion resistant | high load capacity | high load capacity |