430/304 Stainless Steel Scourer Wire for Uniform Mesh Structure

Scourer wire is used for stainless steel scouring pads and cleaning mesh, where wire diameter consistency and surface condition determine how evenly the mesh forms and how the finished pad performs. This wire is supplied in 430 and 304 grades, with diameters selectable within the 0.15-12mm range.

Grade 430 is a ferritic stainless steel chosen for cost efficiency in general cleaning pads; 304 is selected where higher corrosion resistance is required, particularly for pads used with water or detergents. Wire is cold drawn and bright finished, then packed in coils or on spools for knitting and crimping lines.

Specifications

Applications

Scouring Pads

Wire for knitted and crimped scouring pads used in household and commercial cleaning.

Cleaning Mesh and Scrubbers

Mesh structures for kitchen scrubbers, pot cleaners and industrial cleaning pads.

Kitchen and Food-Service Cleaning

304 grade wire for pads used with water, detergents and food-contact cleaning where corrosion resistance matters.

General Mesh Products

Wire sections for decorative and functional mesh where a clean metallic surface is required.

Product Advantages

• Uniform diameter for even mesh - diameter and tolerance are inspected per batch, supporting consistent mesh density and pad structure.
• Grade choice for cost and corrosion - 430 for cost-efficient general pads; 304 for water and detergent exposure; 316 available on request.
• Controlled temper - soft or half-hard condition can be specified to match knitting and crimping behavior.
• Bright inspected surface - surface condition is checked for defects that would affect the finished pad appearance.
• Full range 0.15-12mm - one supplier for scourer wire and heavier mesh wire, with traceable inspection records.

Quality Control

Each batch is inspected for material grade, wire diameter, tolerance, surface condition, temper and packing against the agreed specification. Test reports are available per shipment.

Quick Selection Guide

1. Confirm the product type (scouring pad / cleaning mesh / other)
2. Select the grade (430 for cost efficiency; 304 for water and detergent use)
3. Confirm the wire diameter within 0.15-12mm
4. Specify the temper (soft / half-hard)
5. Confirm the supply form (coil or spool) and packing

Send your grade, diameter, temper and target product for a technical confirmation and quotation.