0.3 - 0.8mm Pre-Painted Steel Aluminum Zinc Metal Roofing Corrugated Sheet Roll Forming Machine Machine


1. Technical Parameter

This high speed corrugated Roll Forming Machine can produce material thickness range 0.3-0.8mm, material PPGI, galvalume steel, aluminum steel and galvanized steel, also we can customized the machine according to your drawing, specially the pitch and height of each wave, for the machine speed, it is high speed 30m/min, also we can do 40m/min, but it drives by gearbox, high speed roof machine is to do single layer trapezoidal sheet or single layer corrugated iron sheet.
Its products are widely used in roof and wall system in workshop construction and housing construction.

2. Machine lists

3. Profile Drawing
Metal Corrugated Sheets, for metal roofing and cladding, dimensions are often tailored for specific structural profiles. Here are some typical ranges from commercial data:

• Thickness: Usually between 0.12mm to 0.4mm and 0.3mm to 0.8mm for standard roofing sheets.

• Width (Total/Effective): The overall width can range from about 600mm to 1250mm. However, the effective cover width (the width that actually covers the roof after overlapping) is smaller. For example, a 1000mm wide sheet might have an effective width of 880mm to 915mm after overlapping. A common example is a sheet with a total width of 990mm and a cover width of 950mm

4. Main Features

1.This double roll forming machine can produce two different profiles with one machine, sharing same machine base frame, un-coiler, PLC control system, which can much save of your cost.

2.More reasonable forming process design; More roller steps with competitive price.

3.The whole line consists of un-coiler, pre-cutting system, feeding system, roll forming machine with protect guarding cover, post-cut device, PLC control system, and so on.