Sample rack

Stainless steel SUS #201 perforated steel plate storage rack, with a maximum load-bearing capacity of 30KG on a single layer. The height is adjustable at the same time.

Hall element collects current signal

Hall elements are used to collect the current generated when the short-circuit system is short-circuited, avoiding the generation of contact resistance, and the data transmission is stable and accurate;

Lead hole

There is a lead hole with a diameter of 50mm on the left side of the box for test wires to pass through.

Chamber door

High-strength hinges are used to fix the door, and at least 2 sets of explosion-proof locks can be installed on the door to fix it.

Explosion-proof pressure relief device

It has the function of exhaust, explosion-proof and pressure relief. The rear of the protective box has a magnet-adsorbed pressure relief door (200*200mm). When strong airflow impacts, the pressure relief door automatically opens and closes to reduce the impact of the explosion.

Lighting

The test chamber door is designed with high-brightness LED lighting to make it easy to see the test conditions in the test chamber.

Smoke exhaust

Powerful smoke exhaust and air induction centrifuge: high temperature resistant, back smoke exhaust port diameter 60mm

High temperature motor

High-temperature-resistant long-axis motor/370W made in Taiwan for high-temperature boxes, multi-wing wind wheel with large air volume and low noise

Heater

Fin-type heat pipe nickel-chromium alloy U-shaped high-efficiency heater automatically calculates high-precision PID+SSR control (calculation cycle: 1~4S can be set), so that its heat loss is equivalent to the heating amount, so it is better than traditional ON/OFF Control saves about 10% power

Thermometer

Made in Taiwan, high precision, DIN specification grade A, ψ4.8mm, SUS #304 stainless steel, PT 100Ω

Explosion proof chain

The door is equipped with 3 explosion-proof chains to prevent the door from being blown out and injuring people.