Clamps for guide bushing DIN9832 VDI-KL Applied for DIN9834 Guide Bushes NAAMS

The retaining clips are used to fixate the DIN 9834 / ISO 9448 guide bushes.

Bushing acc. DIN 9834 GUIDE BUSHING WF 750/1A Bushings acc DIN 9834 and clamps acc DIN 9832

• Permissible deviationsfor dimensions without tolerance specification as per DIN ISO 2768-m.
• UMating material condition Hardness : min HRC35 Surface roughness : Ra 0.8lm or less

• Advantage

• 1. Total Self-Lubricating:No oil or grease required
  The self-lubricating features allow bearings to be used where oiling is difficult, expensive to implement, and where grease/oil cannot be used. Excellent lubrication is achieved even under high loads at low speeds.
  
  2. Excellent Wear Resistance:
  Excellent wear resistance is achieved under severe working conditions, such as heavy load, low velocity, reciprocating, oscillating and intermittent motions where the formation of oil film is difficult.
  
  3. Low Coefficient of Friction: 0.04 to 0.2 typical:
  Self-lubrication with specially embedded solid lubricants reduces friction.
  
  4. Wide Operating Temperature Ranges: -40 °C to +300 °C
  Superior performance is exhibited under high and low temperature conditions.
  
  5. Corrosion and Chemical Resistance:
  Performance is not affected by water and caustic chemicals.
  
  6. Designed to Exceed Your Requirements:
  High precision products with close tolerances.
  
  7. Cost Competitive:
  Maintenance, replacement, and end-item downtime cost reduced due to the exceptional service life compared to similar self-lubricating products.

• 

• Catalog No.(Type)	W	L	T	L1	L2	t	d	d1	h	Applicable post diameter
  VDI-KL- 6 ( 6)	20	20	10	7.5	5	6.3	7	11	7	h25nh50
  VDI-KL-10 (10)	32	32	16	11	10	10	11.5	17.5	11.5	h63nh160