Super High Speed Glazed Step Tile Roofing Roll Forming Machine
"Super high speed Glazed Step Tile Roofing Roll Forming Machine" has more than one hundred glazed colors. At the same time, there is no lead-glazed brick glaze that affects the decorative effect. Therefore, western-style tiles and glazed tiles are more and more widely used in modern buildings.
The installation steps of the color steel glazed tile produced by the "Super high speed Glazed Step Tile Roofing Roll Forming Machine" :
1. Construction release: measure the deviation data of the previous process and correct the unqualified parts in time.
2. Keel installation: The color steel glazed tile produced by the "Super high speed Glazed Step Tile Roofing Roll Forming Machine" must be installed with a keel. The keel usually uses galvanized square pipe or wooden keel (fir tree). It should be noted that if a wooden keel is used, the keel needs to be treated with anti-corrosion and insect-proof treatment and cannot be used directly.
3. Installation support: Since the colorful glazed tiles produced by the "Super high speed Glazed Step Tile Roofing Roll Forming Machine" have antique creases downwards every 250~300mm, the strength of the colorful glazed tiles is much lower than that of ordinary colorful tiles. And it is easy to deform and bend, so it is very important to install colored steel glazed tiles. The support layer on the surface is usually made of wood, and in some places it is called an observation board (the name is different for each place). Glazed tiles can only be installed after installing the wooden boards.
4. If the customer's requirements are very high, you can also lay a waterproof breathable membrane or waterproof membrane on the board to further waterproof.
5. Then install the colored color steel antique bricks. Usually, the self-tapping nail is hit at each wave crest position.
6. After installing the above materials, install the roof ridge, the edge and the corner of the color steel drip edge and other accessories.
7. Clean up the garbage on the roof, clean up the site after the completion of construction, and carry out civilized construction.
Main parameters of Super High Speed Glazed Step Tile Roofing Roll Forming Machine
Raw material | |
Material | Colored steel sheet, galvanized steel sheet, aluminum sheet |
Thickness of coil sheet | 0.2-0.8 mm |
Material expand width | 1000mm |
Efficiency width | 840-828mm |
Machine details | |
Roller material | High grade no. 45 forged steel with 0.05mm hard chrome plating |
Shaft material | High grade no. 45 carbon wrought steel |
Cutting blade | Cr12 mould steel with quenched treatment |
Diameter of shaft | 70mm or as your requirement |
Main frame | 300 h steel |
Forming steps | Up layer:9 stations |
Down layer:11 stations | |
Productivity | Up layer:4-5m/min |
Down layer:20-25m/min | |
Hydraulic station power | 4+4kw |
Hydraulic pressure | 10-12mpa |
Appearance size | 5700mm*1500mm*1700mm |
Weight | 6-7tons |
Hydraulic oil | 40# hydraulic oil |
Electric tension | 380v 50 hz 3 phase or as your requirement |
Cut mode | Hydraulic forming after cutting off |
Cutter materia | Cr12 heat treatment |
Electronic control system | Plc, touch screen, encoding counter |
Color | Blue, green or yellow or as your requirement |
Rolling material | 45# steel,roller surfaces polishing, hard plating |
Service life | 10 years |