Experience The Deep Black Effect Of P-237 2K Pure Black Refinish Car Paint
Preparation For Spray Paint
Make sure the work area is well ventilated and wear appropriate personal protective equipment such as a respirator, gloves and goggles.
Gather the materials and tools you need, including plain black paint, thinner, stir stick, weighing equipment, spray gun, and cleaning supplies.
Product Name | P-237 2K Pure Black | Specificatons | 1L/4L/5L |
Features | high covering power, high temperature resistance | Scope of Application | Cars, ships, vehicle, tanks |
Color | Pure Black | Voc | Low |
Storage Method | Store in a cool, dry, ventilated and dark place | Sales Scope | global |
Drying time | surface drying time is 2 hours, actual drying time is 24 hours | Mixing Ratio | paint:curing agent:thinner=2:1:0.3 |
Substrate Treatment | Before spraying the substrate, the substrate must be cleaned, degreased with degreaser, and polished with 800#~1000# sandpaper. Clean it after polishing, and use degreaser to remove oil again. |
Process | The spraying process uses wet spraying to spray 2 to 3 layers on the surface of the substrate. Pay attention to leaving 5 to 10 minutes of evaporation time between each two layers. After spraying, the paint film needs to stand for 10 to 15 minutes. Then bake. Thickness in dry film state: 35~50 microns |
Mixing And Blending
Determine the mixing ratio of pure black paint according to the recipe or guidance provided in the Meklon instructions. This is usually expressed as volume percent or mass percent.
Pour the desired amount of pure black paint into the container.
Follow the recipe and gradually add the appropriate amount of diluent. Note, be careful when adding diluent to avoid too low or too high a color concentration.
Use a stir stick to mix thoroughly to ensure that the pigment and thinner are fully and evenly mixed together.
Preparation For Spraying
Clean and prepare surfaces for spraying. Make sure the surface is smooth and free of oil, dust or other impurities. Surface preparation can be done using appropriate cleaners and sandpaper.
Mask the surrounding area to prevent paint splatter or contamination during spraying.
Finish And Clean
After finishing spraying, check the quality and appearance of the coating. If necessary, grinding, polishing or other repair work can be performed.
To clean spray guns and tools, use the entire Meklon system.