Continuous wave mode 1.3 hours Non-Linear Junction Detector
Introduction
The non-linear Junction Detector HW-24 is used to search and locate electronic devices in on or off state. When a radio frequency signal is detected, the non-linear junction detector generates second and third harmonics.Semiconductor components will display higher grades on the 2nd harmonic.Corrosive semiconductor components will display higher grades on the 3rd harmonic.The non linear junction detector analyzes the 2nd and 3rd harmonics reflected from the target to ensure the rapid and reliable identification of electronic components and corrosive semiconductors.

Specification
Sensitivity | Not less than -120dbm | Modulation mode: | Pulse signal, continuous wave signal; | Output power | Pulse mode:15W; Continuous wave mode : 4W; | Display panel | Display 2nd and 3rd harmonics and sensitivity; | Volume | Volume can be adjusted and can be connected to external headphones | Detection range | Normal power: 0.15 m; maximum power: 0.4 m; | False alarm rate | ≤5% | Signal frequency | 2400 - 2483 MHz | Working time | Pulse mode: 5 hours, Continuous wave mode: 1.3 hours; | Battery parameters | 3.7V 7800mah; | Charger parameters | Input AC100-240V, Output DC 4.2V 3A; | Host size | Length 470mm unfolded, 285mm folded;Width of 128 mm; | Working environment | humidity ≤90%;Temperature -5 ° C to 50 ° C | Weight | less than 1000 g | |






