|  			 Wavelength  |  			 			 1310nm / 1550nm / CWDM  |  		
|  			 Output Power  |  			 			 -6~-1dBm  |  		
|  			 Rx sensitivity  |  			 			 <-18dBm  |  		
|  			 Transmission Distance  |  			 			 SM fiber 10+km , MM fiber 300m  |  		
|  			 Optical connector  |  			 			 Dul LC /FC/ST/SC/MX/ Lemo / Neutrik (optional)  |  		
SDI input/output:
|  			 Signal format  |  			 			 SMPTE 424M, SMPTE 292M, SMPTE 259M  |  		
|  			 Data rate  |  			 			 270Mbit/s - 1.48Gbit/s - 3Gbit/s  |  		
|  			 Cable Equalization  |  			 			 Automatic cable EQ (Belden 1694A cable) 250m @ 270Mbit/s, 140m @ 1.5Gbit/s, 80m @ 3Gbit/s  |  		
|  			 SDI interface  |  			 			 BNC 75 Ohm  |  		
Intercom:
|  			 Camera Optic Adaptor  |  		|
|  			 Interface  |  			 			 4pin XLR(Male) /5pin XLR(Female)/ 3.5mm headset jack  |  		
|  			 Microphone  |  			 			 Mic inputs with mute and pre-amps  |  		
|  			 Headphone  |  			 			 with volume up or down  |  		
|  			 Optic Base Station  |  		|
|  			 Interface  |  			 			 Input:3pin XLR Female , Output: 3pin XLR Male or 5pin XLR or 3.5mm headset jack  |  		
|  			 Audio  |  			 			 Balance or unbalance line level  |  		
Tally:
|  			 Camera Optic Adaptor  |  		|
|  			 Interface  |  			 			 4pin air head or 3pin mini XLR  |  		
|  			 Output  |  			 			 Dry Contact Closure or wet +12V  |  		
|  			 On: short or +12V Off: open or 0V  |  		|
|  			 Optic Base Station  |  		|
|  			 Interface  |  			 			 DB9(Male)  |  		
|  			 Input  |  			 			 Dry Contact Closure or wet  |  		
|  			 On: short to GND or TTL low Off: open or TTL high  |  		|
Remote:
|  			 Camera Optic Adaptor  |  		|
|  			 Interface  |  			 			 8pin air head or 8pin sony’s remote interface  |  		
|  			 Data  |  			 			 RS422 /RS232/RS485  |  		
|  			 Optic Base Station  |  		|
|  			 Interface  |  			 			 DB9(Male) or 8pin sony’s remote interface  |  		
|  			 Data  |  			 			 RS422 /RS232/RS485  |  		
|  			 RJ45  |