61 Watts Mini Water Cooler Dispenser 85-95 Degrees Centigrade Small Cute Appearance with good sales on Amazon. To get more know products information, please visit the below link on Amazon from one of our UK customers, thanks!
https://www.amazon.co.uk/dp/B078XBL9HJ
https://www.amazon.co.uk/dp/B01NAP7OU5
Products component checklist :
Technical and Replacement filters
| | System Specification |
| Electrical Requirements | 220 - 240V , 50/60 Hz |
| Input cooling | 61 Watts |
| Filter replacement model | |
| Filter cartridge life | 150 litres or 2 months |
| Filter cartridge flow rate | 100-400ml/minute |
| Filter reduction capabilities | Chlorine, lead, copper, etc |
| Products weight | 3.2 KGS |
| Total water tank capacity | 8.5L |
| Filtered water tank capacity | 5L |
| Unfiltered water tank capacity | 3.5L |
Before first use :
- Wash and rinse out the plastic water tanks thoroughly before use
- Remove the filter from its packaging then fully cover and soak in cold clean water for approximately 15 - 30 minutes then rinse off under cold clean running tap water until see the clear water then will start for using
- You may notice a fine black dust come out of the filter, this will happen on all new filters and when water is filtered through it the first couple of uses . This is no cause for alarm . It is just the dust from the activated carbon inside the filter. Although it looks unsightly , it will not harm you.
Prepare Filter
- Remove filter cartridge from plastic cover
- Do not lose the filter cartridge O-Ring
- Soak filter cartridge in water for approximately 20 minutes
- Shake filter while under water to remove dark carbon particles and any trapped air
Insert filter and ensure it sits flat and fully seated

Assembly:
- Ensure Drain Plug underneath unit is secure on the unit
- Place unfiltered water chamber on to the Filtered Water Chamber
- Place Filter cartridge into the unfiltered Water Chamber. Ensure Filter cartridge is secure
- Place top on top of water Chamber
- Turn the switch to "ON" at the back of the unit
- Empty water into the unfiltered water chamber, allow water to run through to the Filtered water Chamber
- Once the Filtered water chamber is filled, push and hold the tap down until water comes out of the tap
When you turn on the switch to " on" at the back of the unit , you will see RED LIGHT indicating the water
cooler is chilling the water . When the indicator light from RED LIGHT to BLUE LIGHT indicating the water
approximatly 800ml cold tank has fully chilled .
Red Light : Water is chilling
Blue Light: The water has fully chilled for drinking
Technical and Replacement filters
Maintenance :
- Replace filter after 150 litres or 2 months of use or whichever comes first
- If the taste , smell or flow rate changes , it is recommended you change the filter immediately
- Sanitise the unit fully every 1 to 2 weeks. This will be based on the customers' requirement.
Position :
- The unit is designed for light use at home or in a small office
- If the unit is damaged in any way , refrain from using it
- Keep away from direct sunlight
- Ensure the unit is appropriately earthed
- Ensure the unit has 100mm of ventilation all round
- Do not place near a heat source
Contact details:
NINGBO GOOD WATER SOURCE ENVIRONMENTAL PROTECTION ELECTRICAL APPLIANCE CO.,LTD
CONTACT PHONE(WHATSAPPLE): (86) 13884494576
CONTACT E-MAIL: jackliu@miniwatercoolerdispenser.com
WECHAT: Jackliu8886
SKYPE: jackliu06316
Besides, to get more know our products information, please visit the below link on Amazon from one of my UK customers, thanks!
https://www.amazon.co.uk/dp/B078XBL9HJ
https://www.amazon.co.uk/dp/B01NAP7OU5