The Dual Mass Flywheel (DMF) with OEM number 06J-105-266-AE (also listed as 06J105266AE, 06J 105 266 AE) is a verified OEM-grade direct replacement for a wide range of Audi and Volkswagen vehicles equipped with 1.8/2.0L TSI/TFSI EA888 Gen2 engines and the DQ250 6-speed DSG automatic transmission.

• Real Shop Test Data: Precision-engineered 280mm diameter with 129 teeth — verified against VAG Group OEM specifiions
• Proven Durability: Built with premium-grade cast iron with precision-machined friction surface — rated for 160,000+ km (100,000+ miles) under normal operation
• Installation Success Rate: 99% direct bolt-on fitment — confirmed across thousands of repair orders for VAG DQ250 DSG vehicles
• OEM Cross-Reference Verified: Replaces 06J105266AE, 06J105266AH, 4150736090, DMF205

Compatible Brands: Audi, Volkswagen (VW), SEAT, Škoda

Our manufacturing and inspection processes ensure every flywheel meets or exceeds VAG OEM standards.

Pre-Installation Checklist:

• DSG transmission must be removed for flywheel access
• Inspect the crankshaft flange for damage or wear
• Use NEW flywheel bolts — they are torque-to-yield and must be replaced
• Replace the rear main seal while the flywheel is removed (recommended)
• Always replace the dual clutch assembly simultaneously with the flywheel

Installation Guidelines (Reference workshop manual):

1. Safely raise the vehicle and support it on jack stands
2. Remove the DSG transmission assembly
3. Remove the old flywheel bolts and carefully remove the old flywheel
4. Clean the crankshaft flange mounting surface thoroughly
5. CRITICAL: Install the new flywheel with NEW bolts
6. CRITICAL: Torque the flywheel bolts in the correct sequence and to the manufacturer's specified torque settings + angle (refer to vehicle-specific workshop manual)
7. Install the new dual clutch assembly
8. Reinstall the DSG transmission
9. Refill with correct DSG transmission fluid
10. Perform a DSG basic settings adaptation using a diagnostic scan tool
11. Test drive to verify smooth gear changes and check for unusual noises

Maintenance Schedule:

• Inspection: During DSG service or if vibration/rattling symptoms appear
• Replacement: Recommended at 160,000 km (100,000 miles) or immediately if failure symptoms appear
• Note: Pairing your LuK RepSet with a new LuK flywheel is a smart, cost-effective alternative to resurfacing

• Packaging: Each flywheel is securely packed in a heavy-duty carton with foam inserts to prevent shipping damage
• Includes: Flywheel assembly + Pilot bearing
• Note: Flywheel bolts are not included — must be purchased separately
• Suitable for: Wholesale distributors, auto parts retailers, European specialty repair shops, and DIY enthusiasts