Front Oxygen Sensor 06J 906 262 AA 06J906262AA for Audi A3 8P / VW Golf/Jetta/Passat/CC/Tiguan 2.0T TSI — OEM Premium Wideband O2 Sensor

The Front Oxygen Sensor (Lambda Sensor) with OEM number 06J-906-262-AA (also listed as 06J906262AA) is a verified OEM-grade direct replacement for a wide range of Audi and Volkswagen vehicles equipped with 2.0L TSI/TFSI engines. Manufactured to exacting OEM specifiions, this wideband sensor is a critical component of the engine management system.

If your oxygen sensor is failing, you may experience one or more of the following symptoms:

1. Check Engine Light (CEL): Illumination on the dashboard
2. Reduced Fuel Economy: Noticeable decrease in miles per gallon (MPG)
3. Poor Engine Performance: Hesitation, rough idle, or lack of power during acceleration
4. Failed Emissions Test: Elevated hydrocarbon (HC) or carbon monoxide (CO) levels

Compatible Brands: Audi, Volkswagen (VW)

Each oxygen sensor meets or exceeds VAG Group's stringent standards.

Installation Guidelines:

1. Allow the exhaust system to cool completely
2. Disconnect the negative battery terminal
3. Loe the front oxygen sensor on the exhaust
4. Disconnect the electrical connector from the sensor wiring harness
5. Using an oxygen sensor socket, carefully remove the old sensor
6. Clean the threads in the exhaust bung with a thread chaser if necessary
7. CRITICAL: Apply anti-seize compound to the threads of the new sensor
8. Install the new sensor and torque to manufacturer's specified settings (typically 35-45 Nm)
9. Reconnect the electrical connector securely
10. Reconnect the negative battery terminal
11. Start the engine and check for exhaust leaks
12. Clear any diagnostic trouble codes using an OBD2 scanner

Maintenance Schedule:

• Inspection: During routine servicing or if Check Engine Light appears
• Replacement: Recommended at 160,000 km (100,000 miles) or immediately if failure symptoms appear
• Note: Oxygen sensors degrade slowly over time — proactive replacement can restore fuel economy and performance

Each oxygen sensor is securely packed in protective packaging to prevent shipping damage. Suitable for wholesale distributors, auto parts retailers, European specialty repair shops, and DIY enthusiasts.