Auto Laminator 1450mm High Accuracy Flute Lamination Machine Laminating Corrugated Carton

Working principle

The paper is sent out by the paper feeder and sent to the actuator of the gauge mechanism to detect the paper

Send out;The paper and the paper are sent to both sides of the paper respectively after the paper is coated with glue by the rubber wheel

Synchronization detector, after detection by the controller calculation of the paper and base paper error, and from the paper two

The side servo compensator compensates the surface paper to a predetermined position for bonding, and then passes through a pressurized conveyor

Press the paper and transfer to the paper receiver to collect the finished product

Applied materials

Tissue paper -180 ~ 800g/m of thin paper, cardboard.

Base paper -0.5 ~ 10m/m of cardboard, single-sided paper, multi-layer paper, pearl board, honeycomb board, etc.

Glue - water - based glue, PH between 6 and 8, can be applied to paper glue.

Specifics:

BRANCH INTRODUCTION:
1. BOTTOM PAPER FEEDING

Use imported Servo motor electric controlling system, with Japan NITTA suction belt to make suction power inverter, and belt cleaned by water roller; Patented technology to ensure corrugate and cardboard goes out smoothly and simple operation.

2. TOP SHEET FEEDING MECHANISM

Equipped with high speed auto dedicated feeder, both paper lifting and feeding nozzle can freely adjust angle to the paper, to ensure that whether thick or thin paper can be delivered rapidly and smoothly.

3. ELECTRICAL SYSTEM

Designed in the accordance with European CE requirement, ensure machine stability, high efficiency and low failure. Using man-machine interface and PLC combination, display all the information, such as warning, error detect, failures, and operating speed, etc on the screen at a glance.

4. PRE-STACK PART

Pre-stack pile of paper under the condition of non-stop, improve efficiency.
The special design of the pre stack paper frame, save time and effort.

5. TRANSMISSION

With imported double teeth belt drive and Switzerland ROSTA tension device ensure the drive accurate, stable and low noisy.

6. POSITIONING SYSTEM & GLUE ROLLER

The use of multiple sets of photoelectric sensor at bottom sheets relative position, control top sheets on both sides of the servo motor to do independent compensation action, so that accurate positioning of top paper and the bottom paper.

Stainless steel roller, never rust, after narrowly grinding, guaranteed the minimum amount glue coated evenly.
Down roller be cleaned by water roller.

7. TOUCH SCREEN OPERATION SYSTEM

It adopts the centralized control of the touch screen, realizes the man-machine dialogue with the high-resolution man-machine interface, and realizes the real-time dynamic monitoring of operation and fault, making it more convenient to adjust and troubleshoot