5G Router & Industrial Ethernet Switch
► Support 8x10/100/1000Mbps RJ45 Ports, 4 x 1.25G SFP ports and 1 x 5G uplink.
► Gigabit interface 10/100/1000Mbps adaptive, full/half duplex, MDI/MDIX adaptive mode.
► Support QoS, IEEE802.1p and ToS/DiffServe to improve communication quality.
► Support different levels of network management of SNMP V1/V2C.
► Real-time broadcast storm monitoring and control (including broadcast, multicast, unknown unicast and other storm type detection)
► Embedded Web server, which can be managed and configured remotely through browser.
► Dynamic IGMP Snooping support to filter multicast traffic.
► Meet the requirements of trouble-free operation in strong electromagnetic interference environment.
► Full duplex flow control and half duplex back pressure flow control
► Port VLAN and IEEE 802.1Q VLAN
► Trunk port convergence
► Online firmware update
Overview
This 5G Router & Industrial Ethernet Switch communication route is specially designed and developed for the application of power high-speed communication network, using 5G industrial security module and domestic two-layer switching chip.
Technical Indexes
|   Appearance and heat dissipation  |  |||
|   Size  |    74mm * 160mm * 122mm  |  ||
|   Material  |    Aluminum Alloy  |  ||
|   Cooling mode  |    No fan, silent  |  ||
|   Mounting option  |    DIN Rail  |  ||
|   Power supply and environment  |  |||
|   Power input  |    DC12V/24V/48V  |  ||
|   Power port  |    5-pin Terminal Block, Redundant Power  |  ||
|   Power consumption  |    less than 20W  |  ||
|   Humidity  |    5% ~ 95% without condensation  |  ||
|   temperature grade  |    industrial grade, -40 ~ 85℃  |  ||
|   Protection level and availability  |  |||
|   Protection level  |    EC/EN6100-4 industrial protection  |  ||
|   MTBF  |    > 50000 hours  |  ||
|   Connectors  |  |||
|   Gigabit Ethernet Port  |    8 x 10/100/1000Mbps  |  ||
|   Gigabit Fiber Port  |    4 x 1000BASE-X  |  ||
|   5G antennas  |    2  |  ||
|   Console Port  |    2  |  ||
|   Other  |    1 x USB, 1 x SIM, 1 x Reset  |  ||
|   operating system  |  |||
|   Operating system  |    Linux  |  ||
|   Online upgrade  |    support  |  ||
|   management  |    Web-based network management  |  ||
|   Switch protocols and functions  |  |||
|   Remote access control  |    support  |  ||
|   Standard protocols  |    IEEE802.3u, IEEE802.1p, IEEE802.1q and IEEE 802.3ad  |  ||
|   Multicast  |    supports IGMP and IGMP Snooping multicast protocols.  |  ||
|   VLAN  |    supports VLAN division.  |  ||
|   QoS  |    supports QoS management.  |  ||
|   Ports  |    Supports port aggregation, port rate limitation and broadcast storm suppression.  |  ||
|   IPv  |    supports IPv4 static routing settings  |  ||
|   ACL  |    supports port MAC address binding  |  ||
|   Ring network protection  |    supports  |  ||
|   Port mirroring  |    supports  |  ||
|   5G Features  |  |||
|   NR features  |    supports SA/NSA networks.  |  ||
|   4G/5G  |    automatic switching between different 4G/5G networks.  |  ||
|   Modulation mode  |    uplink and downlink 256QAM  |  ||
|   cryptographic algorithm  |    supports  |  ||
|   5G output power  |    N41: 23dBm±2dB N78: 23dBm+2dB/23dBm-3dB N79: 23dBm+2dB/23dBm-3dB  |  ||
|   receiving sensitivity  |    N41: 2 antenna 10mhz/30khz SCS <-95.1dbm N78: 2 antenna 10mhz/30khz SCS <-96.1dbm N79: 2 antenna 40mhz/30khz SCS <-89.7dbm  |  ||
|   LED  |  |||
|   Function  |    LED  |    Status  |    Definition  |  
|   Power  |    PWR1  |    ON  |    PWR1 is connected and supplied normally.  |  
|   OFF  |    PWR1 is not connected or the power supply is abnormal.  |  ||
|   PWR2  |    ON  |    PWR1 is connected and supplied normally.  |  |
|   OFF  |    PWR1 is not connected or the power supply is abnormal.  |  ||
|   RUN  |    RUN  |    Flashing  |    system is operating normally.  |  
|   ON/OFF  |    Abnormal system operation  |  ||
|   Alarm  |    ALM  |    ON  |    Equipment alarm  |  
|   OFF  |    Equipment without alarm  |  ||
|   Gigabit Fiber Port  |    G9 ~G12  |    ON  |    The port has established a valid network connection.  |  
|   Flashing  |    The port has network activity.  |  ||
|   OFF  |    The port has not established a valid network connection.  |  ||
|   Each Ethernet RJ45 port has two indicators, the yellow indicator is the port rate indicator and the green indicator is the connection status indicator.  |  |||
|   Ethernet Port  |    1000M (Yellow)  |    ON  |    1000M working state  |  
|   OFF  |    10M/100M working state  |  ||
|   L/A  |    ON  |    The port has established a valid network connection.  |  |
|   Flashing  |    The port has network activity.  |  ||
|   OFF  |    The port has not established a valid network connection.  |  ||
Ordering Information
|   Model  |    Description  |  
|   LNK-IMC408G-5G-R  |    5G Router & Industrial Ethernet Switch communication route, with 8x10/100/1000Mbps RJ45 Ports, 4 x 1.25G SFP ports and 1 x 5G uplink.  |  
Tags: