1. The machine is absolutely top processing technology, rack welding machine, the high temperature quenching treatment, so that the rack with high rigidity, high strength; tool with a special vacuum high temperature treatment to extend its service life.
2. The machine standard is equipped with punching station, channel and angle steel cutting station, thick plate cutting station, round steel and square steel cutting station, cutting angle station. Optional red hole, plate bending, channel steel punching, shutters and pipe cutting angle and other accessories.
3. Standard equipped with five stations and dual hydraulic workstations. Can work independently at the same time. The machine does not need to carry out any level of debugging, placed in place after use. Optional CNC control system to increase the automatic punching, and shear efficiency.
4. The use of hydraulic transmission, the whole structure is reasonable, light weight, low noise, light and reliable and has overload performance.

Standard Series:

Only one operator can work on this machine.

With one standard set of unit, including one pump, one motor and one valve.

Manual clamping

Without temperature cooling system

S series:

Only one opertaor can work on this machine.

With one standard set of unit, including one pump, one motor and one valve.

Manual clamping

Automatic clamping system in angle and plate shearing station

Temperature cooling system

D series:

Dual working ironworker(which means two operators can work on the machine at the same time)

With two sets of hydraulic units, including two pumps, two motors and two valves.

Automatic clamping system in angle and plate shearing station

Temperature colling system

Standard Functions:

Punching; Angle, C-channel Punching; H-beam Punching

Angle Shear; Round Bar Shear; Square Bar Shear; Flat-Bar Shear; Angle Miter Shear

Notching;

Optional Functions:

Pipe Notcing

Pipe Punching

Press Brake

Angle Bending

Radius Corners

Rounding off Corners

Bialateral Rounding off

Vee Nocthing

C-channel Jointing

I-Beam Shear

Channel Shear

	Punching Station A full range of punches and dies are available for various punchig needs. Quick change retaining nut system for fast punch tooling change. Thoughtfully designed stripper for visibility, safety andease of use. A large 2-piece table with scales and gauging stops isstandard on all models. Stripper with interchangeable plates of various openings to minimize deformation is standard on all models
Flat Bar Shearing Station Specially machined upper blade to give a clean shear with minimum distortion. Lower blade has four usable cutting edges. Variable degree miter-cutting on angle flange. Easily adiustable hold-down. Support table with guides for accurate positioning.
	Angle Shearing Station Single shear with no material loss and minimal deformation. 45° miter-cut is easy and clean. Stationary blades with four usable cutting edges. Selectable corner radii on moving blades for optimumresults on small or large angles
Bar Shearing Station One hold-down for various sizes of square bar shear-ing and round bar shearing. Optional channel and section bar shear tooling is available for most models.(See specification chart fordetails)
	Notching Station ldeal for notching of flat bars and angles. Electrically interlocked safety quard for maximumsafety and visibility. Gauging table included with stops for precise positioning.