Product Overview

The Dynisco TPT463E-5M-6/18 is a combined melt-pressure and melt-temperature measuring device for polymer extrusion and plastics-processing equipment. It provides an industry-standard 3.33 mV/V pressure signal together with a removable Type J thermocouple, allowing pressure and temperature to be measured at one process location.

The 5M range corresponds to a nominal pressure range of 0 to 5,000 psi. The 6/18 configuration identifies a rigid sensing stem combined with an approximately 18-inch flexible capillary section. This construction helps isolate the electrical housing from high process temperature and provides installation flexibility around extruder barrels and melt lines.

Main Product Information

Measurement Configuration

The pressure channel uses a strain-gauge bridge output intended for a compatible pressure indicator or controller. The temperature channel is electrically separate and must be connected to an input configured for a Type J thermocouple. The pressure excitation, thermocouple wiring and connector pin assignment must be checked before commissioning.

Typical Applications

• Polymer extrusion pressure and temperature monitoring
• Plastic sheet, pipe and profile production
• Film and packaging-material extrusion lines
• Injection-molding melt systems
• Extruder barrel and die-pressure measurement

Replacement and Compatibility Checklist

Before ordering, confirm the complete model, 5,000 psi range, 1/2-20 UNF thread, rigid and flexible lengths, Type J thermocouple, connector type, pressure-indicator input and original wiring. A similar pressure range alone does not establish interchangeability.

Inquiry and Supply Notes

Please provide the full nameplate, original model, required quantity and equipment information. Availability, documentation, electrical connection and configuration matching should be confirmed during quotation.