![](\"/photo/deyiabglue/editor/20240829100546_67436.jpg\")
\nBonding metal, glass, ceramic, marble, wood and many rigid plastics.
\nNot Recommended For :
\nPolyethylene, polypropylene, Nylon,Teflon or flexible materials.
\nApplying at temperatures lower than -60°C or above 100°C.
\nContinuously wet areas or water immersion.
Application Method
\n(1). Surface of adherent has to be cleaned, dried.
\n(2). A/B components should be mixed 1:1 in weight in proper amount. Usually, initial curing can be reached within
\n5-10Minutes(25°C) and available in 1 hours. full Bonded joint can be used after 24 hours.
\n(3). After bonding the product, according to the requirements of the bonding process on the treatment, so as not to affect the
\neffect.
\n(4). This product is partial thick, will be a normal phenomenon and does not affect the bonding effect.
\nApplication
\n\n(1). Surface of adherent has to be cleaned, dried.
\n(2). A/B components should be mixed 1:1 in weight in proper amount. Usually, initial curing can be reached within
\n5-10Minutes(25°C) and available in 1 hours. full Bonded joint can be used after 24 hours.
\n(3). After bonding the product, according to the requirements of the bonding process on the treatment, so as not to affect the
\neffect.
\n(4). This product is partial thick, will be a normal phenomenon and does not affect the bonding effect.
\nApplication
\n \n
\nTechnical Parameters
\nColor A: green; B: red;
\nViscosity (cps/25\u2103) A:4000~6000; B:4000~6000
\nOperation time (25\u2103/100g) 5 minutes
\nCuring time (25\u2103/100g) surface dry: 5~10 minutes, full cure: 24 hours
\nShear strength (MPa) ≥16
\nImpact resistance (kj/m2) ≥18
\nTemperature (\u2103) -60~+100
\nShelf life 12 months
\nColor A: green; B: red;
\nViscosity (cps/25\u2103) A:4000~6000; B:4000~6000
\nOperation time (25\u2103/100g) 5 minutes
\nCuring time (25\u2103/100g) surface dry: 5~10 minutes, full cure: 24 hours
\nShear strength (MPa) ≥16
\nImpact resistance (kj/m2) ≥18
\nTemperature (\u2103) -60~+100
\nShelf life 12 months
