Bb face Small molecule non-invasive technology
By using medical grade air compressor to compress the air to a strength level of 7kg, and then instantaneously release
all energy to blast all solutions in the storage tank into small molecules. Small molecules act instantaneously at a pressure of 6kg on the skin, and the nutrient solutions blasted into small molecules can instantly presses the cells
of the spinous layer, the granular layer, the transparent layer and the stratum corneum to a channel under strong
pressure, then nutrient solutions can instantaneously effffect on the basal layer.Operation steps of Bb face1.Clean the skin before use the device (Please remove the makeup with cleansing water and then clean with facial cleanser if there is makeup)
2.Connect the power cord and press the button on the back of the device to turn on the device
3.Mode selection
The mark of meso gun on the lower right of the device mirror is the choice of mode. There are 3 modes available, from left to right: fifirst mode is 0.5 seconds/time, second mode is 1 second/time, third mode is 1.5 seconds/- time. The default is the fifirst mode (0.5s/time). The second mode(1second/time) is recommended for the treatment
4. Please fifill up the storage tank, it can be fifilled with hydrating essence, whitening liquid, hyaluronic acid original liquid, water light essence, freeze-dried powder and other products.
Example: Using needle injector to draw 5ML of the original solution to the tube, and then dilute the original solution with physiological saline (because the original solution is relatively viscous), dilute it and then inject it from the reservoir inlet
5 .The metal knob in the middle of the operating handle is used to adjust the liquid volume. For the initial operation, it is recommended to adjust the liquid volume as small as possible to avoid wasting the product if it is unfamiliar with the device
6.Set up the mode, fifill the product into the storage tank, adjust the injector flfluidity, by pressing the gray button on the handle to start operation.
7. It is recommended to apply a hydrating mask or a medical repair mask after the operation
Note: After each use, please use alcohol to clean the tip, and inject hot water or alcohol into the reservoir, adjust the amount of flfluid to the maximum, open the oxygen injection mode, and clean the nutrients remaining in the barrel for avoiding product blockage
Oxygen injection operation
1.Turn on the power switch on the back after the device is connected to the power
supply
2. Selection mode:
Tap the ‘machine’ on the front of the device and the light is on, indicating that the oxygen injection mode has been selected
3. Fill products or solutions
Fill up the storage tank with the hydrating essence, whitening liquid, hyaluronic acid original liquid, water light essence, freeze-dried powder and other products
4. Adjust the liquid flfluidity:
The metal knob in the middle of the operating handle is used to adjust the volume of the liquid. For the initial operation, it is recommended to adjust the amount of liquid as small as possible to avoid wasting the product if it is unfamiliar with the
instrument
Example: First, use the liquid applicator to draw 5ML of the original solution to the
needle tube, and then dilute the original solution with physiological saline (because
the original solution is relatively viscous), dilute it and then inject it from the
reservoir inlet
5. Start operation: Press the gray button on the operating handle and the device will start working.
Operation method
cheek:
It is recommended to use it in a fifixed-point manner, and then move after three shots in a row to move to the next part; when spraying the cheek, it is recommended that the spray direction is perpendicular to the cheek, which is more likely to promote product absorption; and the hand-lifting operation of the hand will be lifted Note: Eyes, nostrils, ears, and mouth are advised not to be directed at the spray (use the positioning cap when operating around the eye and forehead)