I. Basic Model Compatibility
Original Part No.: VOE14660989 (Bucket Cylinder Seal Repair Kit)
Applicable vo lvo Models: EC350E, EC380D, EC380DHR, EC380E, EC380EHR
Matching Bucket Cylinder Specs
Cylinder Bore Diameter: 120mm
Piston Rod Diameter: 80mm
Rated System Working Pressure: 32MPa, Peak Boost Pressure: 35MPa
Net Weight Per Set: Approx. 0.88–1.05kg
II. Seal Components Included
Complete seals for piston rod side and piston side, no extra spare parts required:
1 × Wiper Dust Seal
1 × Main Rod Step Seal (HNBR)
1 × Buffer Seal Ring
1 × Double-Acting Piston Main Seal
2 × Copper Filled PTFE Wear Guide Bands
Full set of supporting O-rings, PTFE Back-up Rings & Shims
III. Seal Material Standards
Main Seals: Wear-resistant HNBR / FKM fluororubber, high pressure & high temperature hydraulic oil resistant
Guide Bands: Copper filled PTFE, low friction & anti-extrusion
O-rings: Oil-resistant NBR rubber, compatible with #46 anti-wear hydraulic oil
Operating Oil Temperature Range: -20℃ ~ +110℃
Designed Working Pressure: 32MPa heavy-duty digging condition
IV. Supply Version Classification
- Genuine vo lvo OEM Kit
Standard OEM groove size with zero tolerance deviation, factory pressure tested, 12-month warranty, ideal for heavy mining digging.
- Brand New OEM Aftermarket Repair Kit
Imported rubber compound with fully interchangeable dimension, direct fit without modification, 3–6 month warranty for regular construction replacement.
- Economy Aftermarket Kit
Standard NBR rubber, low cost, suitable for short-term emergency repair.
V. Applicable Fault Conditions for Replacement
- Oil seepage/dripping on bucket piston rod, weak bucket retraction
- Internal cylinder leakage: Automatic bucket drop, insufficient digging force
- Slow bucket movement, insufficient digging pressure
- Damaged wiper seal causing sediment intrusion and piston rod scoring
- Aged seals & failed buffer ring leading to cylinder impact abnormal noise
VI. Disassembly & Assembly Instructions
- Release residual hydraulic pressure and fully retract bucket cylinder before disassembly
- Polish minor scratches and burrs on piston rod and cylinder barrel, clean metal debris inside seal grooves
- Coat all new seals with hydraulic grease during installation; do not pry seals hard to avoid lip damage
- Install piston guide bands and main seals evenly without twisting or cutting
- Open & close bucket without load for 5–10 cycles to vent air after assembly; check zero leakage before operation
VII. Matching EC380 Excavator Reference
Operating Weight: 39.8–41.6 tons
Standard Bucket Capacity: 1.9m³
Rated Bucket Digging Load: 18600kg
Standard Hydraulic System Flow Rate: 520L/min