This specification outlines the MINI 10PTK, a product from Shenzhen Shouhan Technology Co., Ltd. It is designed for a practical temperature range of -25 to 85C and rated for DC 30V 1.0A. The product adheres to standard atmospheric conditions for testing, including temperatures between 5-35C, humidity of 45-85%, and pressure of 86-106 Kpa.
| Item | Test Conditions | Performance/Specification |
| MECHANICAL PROPERTIES | ||
| Connection Force | After connecting and disconnecting 3 times using standard plug gauge | 3.57Kgf MAX |
| Disconnection Force | After connecting and disconnecting 3 times using standard plug gauge | 1.02Kgf MIN |
| Terminal Strength | 0.1N/m(1kgf/cm) static load applied to terminal tip for 1 min in any direction | No damage to terminal (cracks, looseness, play); electrical and mechanical characteristics satisfied. |
| ELECTRICAL PROPERTIES | ||
| Contact Resistance | Measured at small current (100mA), 1000Hz | 50m MAX |
| Insulation Resistance | Apply 100V DC for 1 min between specified portions | 1000M MIN |
| Dielectric Strength | Apply AC 500V (50~60Hz) for 1 min, trip current 0.5mA between specified portions | No arcing or breakdown |
| DURABILITY | ||
| Solderability Test | Terminal top dipped 1mm in solder bath at 2505 for 50.5 sec | Solder wetting time 3 sec; Soldering area > 75% |
| Resistance to Soldering Heat Test (Reflow) | Preheat: Copper foil surface reaches 180, 120s after PCB enters equipment. Peak temp: 2605 within 20s. | No deformation of case or excessive looseness of terminals; electrical characteristics satisfied. |
| Soldering Iron Method: Bit temp 3305, application time 30.5 sec (no excessive pressure on terminal) | ||
| Humidity Test | Stored at 402 and 90%-96% humidity for 96 Hr, then maintained at standard atmospheric conditions for 1 Hr | Appearance, mechanical, and electrical characteristics satisfied. |
| Heat Test | Stored at 702 for 96 Hours, then subjected to controlled recovery for 1 Hr | No damage on appearance; mechanical and electrical characteristics satisfied. |
| Cold Test | Stored at -253 for 96 Hours, then subjected to controlled recovery for 1 Hr | No damage on appearance; mechanical and electrical characteristics satisfied. |
| Life Test | Without Load: 5000 cycles (insertion/extraction) at 10-25 cycles/min with mating plugs/jacks. | (1) Contact Resistance 0.1 (2) Disconnection Force 0.8 to 2.0N (3) Mechanical and electrical characteristics satisfied. |
| With Load (Rating Condition, Non-Inductive): 5000 cycles (insertion/extraction) at 10-20 cycles/min. | ||
| Temperature Cycling Test | Subjected to 5 cycles of specified temperature conditions (e.g., 70 to -20), then allowed to remain in room ambient for 30 minutes. | No deformation or cracks in molded part. Insertion/Extraction Force: 3 to 20N. Contact Resistance: Max. 30m. Insulation Resistance: Min. 100 M. Dielectric Withstanding Voltage: Min. 100VAC (between terminals). |
| Cold & Heat Shock Test | Subjected to 5 cycles of specified temperature conditions (e.g., 70 to -20), then allowed to remain in room ambient for 30 minutes. | No deformation or cracks in molded part. Insertion/Extraction Force: 3 to 25N. Contact Resistance: Max. 30m. Insulation Resistance: Min. 100 M. Dielectric Withstanding Voltage: Min. 500VAC (between terminals). |