Tct Carbide Straight Router Bits with Two Flute Milling Cutter Woodworking for Wood Cutting

Basic Info

• Shank diameter: 1/2"(12.7mm)
• Total length: 68-90mm
• Application: Engraving and cutting fine, Acrylic, PVC, Nylon, Resin, Wood, Plywood,
• Applicable Materials: Widely used in various materials including plastics, aluminum, circuit board, as well as other precision parts processing.
• Wide Compatibility: End mills are compatible with most desktop CNC machines, as well as other industrial CNC machines. Just make sure you select the correct-sized collet for your device

Why choose a Tct Carbide Straight Router Bits with Two Flute Milling Cutter Woodworking for Wood Cutting?

Tungsten Carbide (TCT) is significantly harder and more heat-resistant than high-speed steel (HSS). This means:

• Longer Life: Stays sharper much longer, especially in abrasive woods or sheet goods.

• Cleaner Cuts: Maintains a sharp edge for smoother finishes.

• Higher Speed Capability: Can handle faster router speeds without overheating.

Why two flutes for Tct Carbide Straight Router Bits with Two Flute Milling Cutter Woodworking for Wood Cutting?

Two flutes offer an excellent balance:

• Efficient Chip Removal: Clears sawdust effectively, preventing clogging and reducing heat buildup during deep cuts or plunge routing.

• Good Surface Finish: Provides a smoother cut than a single flute.

• Sufficient Strength: More robust than a single flute, but clears chips better than three or four flutes in wood.

What router speeds should I use?

Optimal speed depends on the bit diameter, shank size, router power, and material. General guidelines:

• Larger Diameter Bits: Require slower RPM.

• Smaller Diameter Bits: Can handle faster RPM.

• 1/4-inch Shank: Run at higher speeds cautiously; avoid excessive force.

• 1/2-inch Shank: Can handle lower speeds under heavier load more safely.

• Always consult your router's manual and start at manufacturer-recommended speeds. Listen to the router and bit; reduce speed if burning or excessive vibration occurs.

Product Line

Shipping Way