Product Introduction

JLTL Spot Putty is a single component automotive repair filler developed for small surface imperfections during vehicle refinishing work. It can be applied directly with a spreader without additional mixing, helping workshops improve repair efficiency during primer and paint preparation. The material offers smooth spreading performance, quick drying characteristics, and stable sanding results for repairing pinholes, sanding marks, and minor surface scratches.

Key Advantages

• Ready to use without hardener mixing
• Fast drying performance for quicker workflow
• Smooth spreading with good filling ability
• Easy sanding after curing
• Suitable for repairing small paint surface defects
• Stable adhesion on prepared primer and putty layers

Application Areas

• Automotive refinishing workshops
• Car bumper repainting preparation
• Minor body repair before topcoat spraying
• Surface correction for sanding scratches
• Filling pinholes and small imperfections on primer layers

Technical Specifications

FAQ

Can this spot putty be used directly from the can?

Yes. This product is ready to use and does not require hardener mixing before application.

What defects can this product repair?

It is suitable for pinholes, sanding scratches, small dents, and minor surface imperfections.

Can it replace body filler?

No. It is designed for small defect correction only and should not replace body filler or polyester putty.

Is this product suitable for bare metal?

No. It should not be applied directly on metal surfaces.

What is the recommended application thickness?

The sanding thickness should remain below 0.1mm to maintain proper adhesion performance.

Usage Tips

Always clean and dry the substrate before application. Avoid applying the material over large surface areas. Sand the repaired area evenly before applying primer or topcoat layers.