Customized Fruit Pulp Processor Tomato Puree Processor Tomato Puree Maker Mango Pulverizer Mango Pulp Processor Suitable for Fruit Juicing and Pulverizing Processing
PERFORMANCE CHARACTERISTICS OF CRUSHER
Large crushers crush materials through the rapid cutting of multiplepairs of knife sets. They can be used to make foods such as mincedonions, mashed potatoes, garlic paste (minced garlic), vegetable paste,chili peppers, taro, etc. A variety of fruits and vegetables can be madeinto juice, and the thickness of the blades can be adjusted.
This machine is made of stainless steel, is wear - resistant and durable,and meets food hygiene standards. It is simple to operate, easy toclean, safe and reliable. It is suitable for use in catering industries,hotels, canteens, food processing factories and other units.
Adopts a new crushing mechanics principle. The steel sheets are spe-cially treated, with narrow intervals. The product has a high dischargecapacity inside the machine. There are a variety of steel sheets tochoose from according to needs, and they are easy to replace andclean.
Cleaning and Maintenance of Crusher:After each use, the crushing chamber and blades should be cleanedthoroughly, especially for acidic and alkaline substances. When clean-ing the machine, be careful not to turn on the wet power switch or themotor to avoid short circuits and other situations. When sharpeningthe blades, you can remove them from the machine and use an oilstone for grinding.During the grinding process, be careful not to over-heat the blades to prevent annealing.
Installation and Commissioning of Crusher:1.This machine has been debugged before leaving the factory, and itwill only leave the factory when everything is normal. However, due tothe transportation process, it may cause bolts and other parts toloosen. Please check that the equipment is in good condition beforeuse. Before use, adjust the four anchor bolts to be basically levelbefore use.
1.lf this machine uses a three - phase 380V power supply, after con-necting the power supply, first perform a jog test run to check if therotation direction of the blades is correct.It must not reverse.For per-sonal safety, please ground the equipment shell, and the grounding re-sistance must not be greater than 4 ohms.
1.If an abnormal noise is emitted during the initial jog test run, stop themachine immediately, and then check the three screws of the stainlesssteel barrel to see if they are too tight.Then use a wrench to loosenthem slightly, and then perform the jog test run again. Repeat this pro-cess several times until there is no noise.










